Available in 2.5 litres and 10 litres plastic container.

Concrete
PVC, vinyl, and steel plates
Wooden boards on floor in dry locations. Moisture content 7 - 12%
Wooden boards/Plywood on floor tanked with Alfix Sealing Membrane
Substrates from PVC, vinyl, and steel plates are generally not considered suitable for exterior use or in areas exposed to frequent or permanent water.

The surface should be clean and free from dust, grease, and laitance. There should be no blooms or crack formations. Residues from grease or soap can be removed with Alfix Deep Cleaner.
Mat or sand PVC and vinyl.
Protect steel from corrosion
On dense surfaces; apply a 1 mm contact layer of adhesive prior to fixing.

Dilute Flexbinder with clean water in the proportion 1:1 and mix with one of the following adhesives: Letfix extra, Letfix extra Less Dust, Letfix Universal, Profix extra, or CombiQuickfix.
The amount of Flexbinder/water depends on whether to use as non-slip wall adhesive or easy-flowing floor adhesive.

Tile fixing should be made in exact accordance with instructions given for each type of adhesive.

Pools with PVC foil
For tile fixing on pool edges use Alfix Normalfix mixed with undiluted Flexbinder. Add 0.4 litre Flexbinder per kg powder and any further adjustment of consistency should be made with clean water only.
For further information, please consult our Technical Services Dept.

NB!
Switch off any underfloor heating.
Additional water or Alfix Flexbinder should not be added to adhesive already starting to set.
This admix improves adhesion which calls for extra attention when cleaning tiles and tools.
Compared to conventional adhesives exclusively mixed with water, setting time may be extended.

NONE

Clean adhesive residues from tools and tiles with water before the admix sets. Once dried, Flexbinder can only be removed mechanically or with solvent.

Tensile strength according to CEN
Compression strength according to EN 196
Deformation test  according to SP Method 1910