CeraFill 20

CeraFill 20

Wide joint grout

  • For ceramic wall and floor tiles, rustic and quarry tiles,and natural stone
  • For interior and exterior use
  • Joints widths: 5 - 20 mm
  • Provides a rustic, coarse grained joint

Product calculator

Product facts


Cement-based powder containing polymer modifiers. Added light stable pigments. Contains quartz sand with grain sizes up to 1.0 mm.


Available in pale grey and grey
Colour swatches available on request.



1.7 - 2.6 kg per m² depending on tile size and joint width.


Available in 5 kg and 20 kg PE lined paper bags.



Joints should be clean, dry, and free from loose particles. Joint depth should appear uniform.
For grouting with joint width under 5 mm Alfix Cerafill 5 colour or Alfix CeraFill 10 colour is recommended.

Expected Result



Surface preparation

Fixing dowels





Tile fixing

Tile fixing



Technical data

Working temperature

+5°C - +25°C
Krav för godkända våtrum +10° C.


2.1 kg/litre (mixed with water)

Working time

3 - 4 hours at +20°C

Foot traffic

After 24 hours at +20°C

Full strength

After 14 days at +20°C

Shelf life

Min. 12 months in unopened bags

How to use


Surface preparation

How to use

Usually, grouting can be made 48 hours after completion of fixing. Add 0.20 litres of clean water per kg powder. Pour the water into a clean container and add the powder while stirring thoroughly with mixing drill until a lump-free and smooth grout is obtained. Allow the mixture to rest for a few minutes before use.

Apply Alfix CeraFill 20 to the surface with a soft rubber squeegee while working diagonally over the joints ensuring that they are completely filled. Remove excess grout immediately while working.
When the grout begins to set, after approx. 15 – 50 minutes, start to slurry off the area using wet sponge frequently rinsed in clean water. Wipe over tiles in broad sweeps until joints appear even and filled. Finally, clean off and finish tiles and joints with only slightly damp sponge.
Any remaining grout film on the surface can be removed after 12 – 24 hours using an acid cleaner, e.g. Alfix Acid Wash.


Switch off any underfloor heating.
Note that the temperature of mixing water will influence setting time.
Protect the joints from heat, draught, and other climatic conditions which will cause premature drying. To prevent premature drying, dampen joints for approx. 24 hours in order to obtain complete hardening.
Do not cover areas just grouted with plastic foil or sheets. Avoid any significant changes in temperature or humidity during hardening process.
Variations in drying conditions as well as heavy use of water when cleaning off may affect the cement and cause visible deviations in joint colour.


Grout residues on tiles and tools should be removed with water before the mix begins to set. Cement-based products harden when mixed with water, hence do not pour surplus adhesive into the drain system.

August 2019

Alfix CeraFill 10 colour Universal grout has been improved, and its name is now being changed to UniversalFuge - CeraFill 10.


Read moreSee the archive here


Hochprofessioneller technischer Service

Kontaktieren Sie uns für Beratung und Unterstützung in Ihrem professionellen Bauprojekt.

So verwenden Sie Ihr Alfix-Produkt

Wie Sie mit Ihrem DIY-Projekt einen reibungslosen Start hinlegen