Frontpage Products Fast-setting screeding mortar "Mix" PlaneMix 80 cement

PlaneMix 80 cement

Rapid setting cement for screeds

To be mixed with sand / fine gravel in the ratio 1:4
Screeding mortar for floors onto joisted timber, concrete, or terrazzo
For bonded or floating screeds and subfloor repairs.
For interior use
Suitable for wet rooms
Foot traffic after 4-5 hours
Ready to receive dense coverings after 24 hours
Ideal for rapid preparation of subfloor
Suitable for underfloor heating
Thickness: 20 - 80 mm

Calculate

Retailers

Product information

Application

Surfaces

Wooden floor constructions onto existing timber joist systems in areas up to 6 m². Joist spacing: 600 mm.
Concrete with or without underfloor heating, existing tiles, or terrazzo for bonded or floating coating on screeds.

Surface preparation

The surface should be dimensionally stable, sound, clean and free from dust and laitance. For application on timber joisting apply rigid/hard insulation between joists and provide floating coat consisting of 2 layers of geotextile. Subsequently install reinforcement mesh, diameter 6 mm. For surfaces requiring bonded coating, broom or brush the surface with a mixture of Alfix PlaneMix 80 Cement and sand 0-4 mm in the ratio 1:4 added and mixed with Alfix PlaneMixPrimer in the ratio 0.3 l primer per kg powder.
Apply the mixture thoroughly by use of brush or broom and work it well into the surface.
Do not allow the slurry to dry before further treatment.
Ensure a room temperature of min. +10°C.

How to use

Add 18 kg PlaneMix 80 cement with 72 kg sand, grain size 0-4 mm and 4,5-8 l water depending on sand moisture content.
Use large mixing container, drum, paddle stirrer or electric drill and mix thoroughly for approx. 2 minutes until a semi-dry consistency is obtained.
Lay out PlaneMix 80 wet-on-wet onto the brushed surface and spread evenly. Upon compaction, level and render the surface by use of smoothing board/straight edge.
If necessary, steel trowel the surface until it appears smooth and closed. Application, rendering and trowelling should be done in one, ongoing work operation. Do not work over larger areas than can be completed within the 1-2 hours working time stated.
Min. bed thickness – bonded screed on concrete: approx. 20 mm.
Min. bed thickness – floating screed: approx. 40 mm.

NB!
Application in wet rooms requires subsequent tanking with sealing membrane ontop of the screeding
mortar.
Additional water should not be added to screeding mortar already starting to set.
Note that the temperature of mixing water will influence working time/pot life.
Over dosage of water will reduce strength and may cause crack formation.
Switch off any underfloor heating and allow 7 days before switching heating back on.
Tanking and tiling: 5-6 hours at +20°C
Dense coverings: 24 hours at +20°C
Levelling:
Use Alfix PlaneMix S8 rapid or alternatively Alfix PlaneMix S12 rapid after 5-6 hours.

Cleaning

Tools and tiles should be cleaned with water before the mortar sets.
Cement-based products harden when mixed with water, hence do not pour surplus PlaneMix into the drain system.

Downloads

PlaneMix 80 cement

Product

Coverage

Packaging

Technical data

Surfaces

Surface preparation

How to use

Cleaning

Guidance

Downloads

Produktinfo

EMICODE

EPD

Sustainable Building

Material Safety Data Sheet