Frontpage Products TopCoat Design TopCoat Design

TopCoat Design

Ultra matt topcoat for levelled design floors

Final treatment of cement-based levelled floors
Interior application in dry rooms
Ultra matt transparent look
Enhances surface strength
Ready for use and easy to apply
High wear and water resistance
Re-applicable in areas subjected to mechanical stress
High waterproofing

Retailers

Product information

Application

Surface preparation

The surface must be suitable for top treatment, stable, dry, and cleaned of dust and slurry.
For further information, contact our service-technical department.

How to use

Always shake container well before use to dissolve any precipitate

For suction control on absorbent substrates, apply Alfix PlaneMix Primer diluted 1:6.

When the PlaneMix Primer is completely dry, apply the first coat of Alfix TopCoat Design with a paint roller
(pile 8 - 10 mm) over the entire surface. Alfix TopCoat Design is applied in an even, uniform layer on the
surface. Avoid formation of pools of liquid on the surface. After drying for a minimum of 3 hours (depend
ing on room and floor temperature), apply the 2nd coat of Alfix TopCoat Design with a paint roller. After
a further 3 hours (minimum), or the next day, a finishing 3rd coat of Alfix TopCoat Design may advanta
geously be applied for a denser finished surface.

A paint roller with a pile length of 8 - 10 mm is recommended.

Residual moisture in the substrate for Alfix TopCoat Design must be max. 85% RH. The temperature of
air, floor and TopCoat Design must be between +15°C and +25°C. Min. drying time at +20°C: 3 hours
between each application. The floor must not be put into use earlier than 1 day after completed treatment
at +20°C.

Before putting the floor into use
Earliest 1 day after completed treatment with Alfix TopCoat Design, it is recommended to wash the floor
twice with Alfix Floor Care diluted with lukewarm water at a ratio of 1 dl Alfix Floor Care to 10 litres of
water. There should be a minimum of 1 hour at +20°C between the first and second wash. The pore filling
results in increased surface strength

Tools should be cleaned with water before Alfix TopCoat Design dries.
Dried Alfix TopCoat Design must be removed mechanically.

Cleaning

Tools should be cleaned with water before Alfix TopCoat Design dries.
Dried Alfix TopCoat Design must be removed mechanically.

Daily maintenance
The floor surface can be cleaned with Alfix Floor Care or another cleaning/maintenance product with similar specifications.

NB!
Avoid polishing the leveling compound surface with a felt pad before treatment with Alfix TopCoat.
Alfix TopCoat Design is recommended for floors in residential areas or other floor areas with a load comparable to residential use.
For floor areas subject to higher loads than residential use, more frequent maintenance should be expected.
The use of protective floor mats is recommended under office chairs with castors.
For chairs and other objects frequently moved across the floor, it is recommended to fit felt pads or similar under chair legs, etc.
Floor mats are recommended at entrance doors.
Spills on the floor must be wiped up before drying.

For further information, contact the service-technical department.

Downloads

TopCoat Design

Product

Coverage

Packaging

Tests

Technical data

Technical enquiries

Surface preparation

How to use

Cleaning

Guidance

Downloads

Product info

Cleaning and maintenance

EPD

Material Safety Data Sheet